$3500 Speakers for ...
 
Notifications
Clear all

$3500 Speakers for $350? Klipsch KL-650 Inspiration

Page 35 / 35

erikcantu
(@erikcantu)
Active Member Registered
Joined: 11 months ago
Posts: 8
 

@123toid Thank you for the honest answer. I'll be cutting out speaker and waveguide holes this weekend, building my router jig template now.


123Toid liked
ReplyQuote
jpgambrell
(@jpgambrell)
New Member Registered
Joined: 7 days ago
Posts: 3
 

Hey Toid do you recall what the corner radius of the waveguides are?  i'll be using X-carve CNC for the speaker baffles. 

 

FYI I ordered the parts to make 3 speakers and some of the cross over components were on back ordered but I did get them in August. 


ReplyQuote

123Toid
(@123toid)
Illustrious Member Admin
Joined: 4 years ago
Posts: 1669
Topic starter  

@jpgambrell 

Honestly, I don't remember. I do remember it was an even number though. So I can't remember if it was half inch, 3/4 in or 1 in.. if we're talking about the Dayton wave guides I'm thinking it was 3/4". but I would do a test cut to make sure.

https://www.youtube.com/123toid


ReplyQuote
jpgambrell
(@jpgambrell)
New Member Registered
Joined: 7 days ago
Posts: 3
 

@123toid thanks for the info!


ReplyQuote

wireburn
(@wireburn)
Active Member Registered
Joined: 2 months ago
Posts: 9
 

@jpgambrell 1" radius through hole and relief cuts for the Dayton V1 waveguide.


123Toid liked
ReplyQuote
jpgambrell
(@jpgambrell)
New Member Registered
Joined: 7 days ago
Posts: 3
 

great thanks!


ReplyQuote

123Toid
(@123toid)
Illustrious Member Admin
Joined: 4 years ago
Posts: 1669
Topic starter  

@wireburn thank you. I couldn't remember offhand

https://www.youtube.com/123toid


ReplyQuote
Page 35 / 35

Newegg

Share:
%d bloggers like this: