Another day, anothe...
 
Notifications
Clear all

Another day, another design - Tang Band/Peerless


ajc9988
(@ajc9988)
Eminent Member Registered
Joined: 2 months ago
Posts: 47
Topic starter  

Now, if the Peerless RMS is correct at 100W, then it will match with the TB at 30W and create a speaker to go from 80Hz to 8000 with amazing off axis (and will continue above that, but that is what I'm comfortable claiming on the off axis).

TB W4-1720
Peerless NE19VTS-04

This is a WTW design. It is setup for a Linkwitz-Riley crossover (2 butterworth second orders in cascade), as now recommended by D'Appolito over his previous recommendation for a 3rd order Butterworth for MTM. Same was used for the highpass on the TB. The dB is using the 30W RMS of the TB and the 100W listed RMS of the Peerless.

image
image
image
image
image
image
image
image

 

This is about 8 3/8 (w) x 15 3/8 (H) x 14 5/8 (D). It's made to max out at 103dB with RMS, so long as the mfrs. were not lying. But, even then, 101 dB if you cut that in half. It will need a sub. Also, this is the Frequency Response for the Peerless to 20K:
https://www.parts-express.com/pedocs/specs/264-1006--tymphany-ne19vts-04-spec-sheet.pdf
 

image

Edit:
*this is for personal use only.


123Toid liked
Quote

Newegg

Share:
%d bloggers like this: