-
Help needed with first crossover design
I am attempting my first speaker build and first crossover design. Right away I thought I got lucky with a fairly even response from a very very simple crossover, but I posted on Reddit and someone who seemed to be very helpful indicated my crossover point was too low for the ND20 tweeter. They suggested targeting the 6k peak of my woofer first and then crossing over higher, but I am really struggling with a parallel notch filter. It seems to have very little effect on the woofer peak.
I would like to keep my part count low because the speaker boxes are pretty small. Was my first attempt so bad? Any tips?
Here are some screen snips of my try: https://imgur.com/a/PuUwzGr
and here is a Drive link with my files if you want to take a stab for yourself: https://drive.google.com/drive/folders/1DoIhUfYebTIobogBeI4uN9YuLlt1tzjD?usp=sharing
The woofer is an Aurasound NS3 and the tweeter is a Dayton ND20. I am using the manufacturer impedance graphs but the frequency graphs are my own, taken in my large bedroom.
I appreciate any help
-
0 Replies
Sorry, there were no replies found.