@tvor-ceasar @123toid You know when I’m doing the enclosure design in winisd and I change the wattage in the signal tab, those drivers are rated at 15watts RMS and since I’ve put two in the enclosure, what should I be adding as the wattage amount? Should it be set to 30? It’s just as I’ve been messing with it it seems impossible to keep the cone excursion below the red line above the tuning frequency unless I drop the power down to around 10-15 watts. I’ve always been unsure about that part when there’s multiple drivers in the enclosure, as I’m not sure how winisd is seeing those two drivers if you understand what I mean.