Home Forums DIY Speakers and Subwoofers Passive Crossover Design Needed Reply To: RE: Passive Crossover Design Needed

  • jamas

    Member
    August 30, 2021 at 9:19 pm

    @mistersota thank you very much. Maybe that is what i need to hear. Because i have allready creating the schematic of my new crossover. No i dont have any of measurements hardware (mic and more), i know is necesary for perfect crossover, but i must work with what i have. It is 2nd Order Linkwitz-Riley with cut off 2000 Hz. I use xsim with C1- 5uF and L1 – 1.27mH with L-pad resistors down to 4dB (94dB have tweeter and 90dB have full range) R1 – 3 Ohm and R2 – 14 Ohm. I hope for good result, when i buy parts. Thank you again…